1.25Gb/s CWDM SFP Transceiver
SOPTIC’s SFP-1.25G-CWDM-1550 Small Form Factor Pluggable (SFP) transceivers are compatible with the Small Form Factor Pluggable Multi-Sourcing Agreement (MSA). The SFP transceivers are high performance, cost effective modules supporting dual data-rate of 1.25Gbps/1.063Gbps and 40km transmission distance with SMF. They are RoHS compliant and lead-free.
Up to 1.25Gb/s data links
Duplex LC connector
Hot-pluggable SFP footprint
Uncooled DFB laser transmitter in 18 possible CWDM wavelengths
RoHS compliant and Lead Free
Up to 80Km on 9/125um SMF
Metal enclosure for lower EMI
Single +3.3V power supply
Low power dissipation <800mW (0~70℃),<1000mW (-40~85℃)
Commercial and industrial operating temperature optional
SFP MSA SFF-8074i Compliant
1x Fibre Channel
Switch to Switch Interface
Switched Backplane Applications
Other Optical Links
Clasp Color Code
Clasp Color Code
1. Connected directly to TX data input pins. AC coupled thereafter.
2. Or open circuit.
3. Into 100 ohms differential termination.
4. 20 – 80 % Measured with Module Compliance Test Board and OMA test pattern.
5. Loss Of Signal is LVTTL. Logic 0 indicates normal operation; logic 1 indicates no signal detected.
6. Receiver sensitivity is compliant with power supply sinusoidal modulation of 20 Hz to
1.5 MHz Up to specified value applied through the recommended power supply filtering
Digital Diagnostic Functions
SOPTIC SFP-1.25G-CWDM-1550 transceivers support the 2-wire serial communication protocol as defined in the SFP MSA. It is very closely related to the E2PROM defined in the GBIC standard, with the same electrical specifications.The standard SFP serial ID provides access to identification information that describes the transceiver’s capabilities, standard interfaces, manufacturer, and other information. Additionally, SOPTIC CWDM SFP transceivers provide a unique enhanced digital diagnostic monitoring interface, which allows real-time access to device operating parameters such as transceiver temperature, laser bias current, transmitted optical power, received optical power and transceiver supply voltage .It also defines a sophisticated system of alarm and warning flags, which alerts end-users when particular operating parameters are outside of a factory set normal range.The SFP MSA defines a 256-byte memory map in E2PROM that is accessible over a 2-wire serial interface at the 8 bit address 1010000X (A0h). The digital diagnostic monitoring interface makes use of the 8 bit address 1010001X (A2h), so the originally defined serial ID memory map remains unchanged. The interface is identical to, and is thus fully backward compatible with both the GBIC Specification and the SFP Multi Source Agreement.The operating and diagnostics information is monitored and reported by a Digital Diagnostics Transceiver Controller (DDTC) inside the transceiver, which is accessed through a 2-wire serial interface. When the serial protocol is activated, the serial clock signal (SCL, Mod Def 1) is generated by the host. The positive edge clocks data into the SFP transceiver into those segments of the E2PROM that are not write-protected. The negative edge clocks data from the SFP transceiver. The serial data signal (SDA, Mod Def 2) is bi-directional for serial data transfer. The host uses SDA in conjunction with SCL to mark the start and end of serial protocol activation. The memories are organized as a series of 8-bit data words that can be addressed individually or sequentially. Digital diagnostics for the SFP-1.25G-CWDM-1550 are internally calibrated by default.
For More Information
Tel: +86-186 8156 5857
Skype /Email: firstname.lastname@example.org