BIDI SFP 1.25G 1550/1310NM DDM 80KM SC connector
SOPTIC’s SFP-BD80-LC15 Small Form Factor Puggable (SFP) transceivers are compatible with the Small Form Factor Pluggable Multi-Sourcing Agreement (MSA), The transceiver consists of five sections: the LD driver, the limiting amplifier, the digital diagnostic monitor, the DFB laser and the PIN photo-detector. The module data link up to 80km in 9/125um single mode fiber.
The optical output can be disabled by a TTL logic high-level input of Tx Disable, and the system also can disable the module via I2C. Tx Fault is provided to indicate that degradation of the laser. Loss of signal (LOS) output is provided to indicate the loss of an input optical signal of receiver or the link status with partner. The system can also get the LOS (or Link)/Disable/Fault information via I2C register access.
Bi-Directional SFP Optical Transceiver
Simplex SC or LC Connectors
1310/1550, 1490/1550, 1310/1490 or other BOSA Tx/Rx combination is available
Max reach up to 160km
AC/AC Coupling according to MSA
Commercial 0 to 70C or Industrial -40 to 85C Case Operation Temperature range
Class 1 Laser International Safety Standard IEC 60825 Compliant
WDM Fast Ethernet Links
Switched Backplane Applications
Other Optical Links
Digital Diagnostic Functions
SFP-BD80-LC15 transceivers support the 2-wire serial communication protocol as defined in the SFP MSA. It is very closely related to the E2PROM defined in the GBIC standard, with the same electrical specifications.
The standard SFP serial ID provides access to identification information that describes the transceiver’s capabilities, standard interfaces, manufacturer, and other information. Additionally, SOPTIC SFP transceivers provide a unique enhanced digital diagnostic monitoring interface, which allows real-time access to device operating parameters such as transceiver temperature, laser bias current, transmitted optical power, received optical power and transceiver supply voltage. It also defines a sophisticated system of alarm and warning flags, which alerts end-users when particular operating parameters are outside of a factory set normal range.
1. Any inquiries will be replied within 24 hours.
2. Professional manufacturer, 15 years manufacturing experience.
3. OEM/ODM available
1) Printing your logo on the cable.
2) Printing your logo on the pull our box, make according to your design.